FIRE-LITE ALARMS
FIRE-LITE
Maintenance personnel can open the station for inspection and address setting without causing an alarm condition Built-in bicolor LED, which is visible through the handle of the station, flashes in normal operation and latches steady red when in alarm Handle latches in down position and the word “ACTIVATED” appears to clearly indicate the station has been operated
Models SD365 and SD365-IV are plug-in type smoke sensors that combine a photoelectronic sensing chamber with addressable-analog communications. The sensors transmit an analog representation of smoke density over a communication line to a control panel. Rotary dial switches are provided for setting the sensor’s address. SD365-IV will support either LiteSpeed or CLIP (Classic Loop Interface Protocol) mode. The possible features available if supported by the control panel are: 1. The sensor’s LEDs can operate in three ways—on, off, and blinking–and they can be set to red, green, or amber. This is controlled by the panel. 2. The remote output may be synchronized to the LED operation or controlled independent of the LEDs. 3. Devices are point addressable up to 159 addresses.
MDF-300(A) is a standard-sized dual monitor module used to monitor and supervise two independent two-wire Style B (Class B) dry-contact initiating device circuits (IDCs) at two separate, consecutive addresses in intelligent, two-wire systems.
LiteSpeed is a communication protocol developed by Fire-Lite Engineering that greatly enhances the speed of communication between analog intelligent devices. Intelligent devices communicate in a grouped fashion. If one of the devices within the group has new information, the panel CPU stops the group poll and concentrates on single points. The net effect is response speed greater than five times that of other designs.